Using WellSchema
Add casing, tubing, packers and perforations
The left panel of the editor holds one section for each kind of component. Add one, fill in its form, watch the drawing change, and save.
By WellSchema Engineering ·
Open a schematic from its well’s page. The panel on the left of the editor holds a section for each component. The drawing follows every change, but nothing is kept until you choose Save at the top of the editor, and each save makes a new version.
Every depth on these forms is MD, and its label says so. Each section has its own add button at the foot of its list, and a new component starts with example depths and sizes, so change them all. Selecting a component on the drawing opens its form.
Casing
- Open Casings and choose Add Casing. A schematic created from scratch already holds a set of casing strings to change.
- Click the casing string to open its form and set its Type: Conductor, Surface, Intermediate or Production.
- Set Hole Size, Top, Bottom and TOC. A first casing string starts as a Driven Conductor, which has neither Hole Size nor TOC. Turn that off for a drilled Conductor, which requires both. On any other Type, Hole Size is required and TOC is optional.
- Under Sections, set each section’s OD, Weight and Grade from the lists, and its Connection if you know it. Add Section splits the last section in two for a tapered string. Each section starts where the one above ends, so set the depth where two meet as the upper section’s Bottom.
Tubing
- Open Tubing and choose Add Tubing.
- Set Top and Bottom. Top must be shallower than Bottom, or the card turns red.
- Choose OD, then Weight, then Grade. Each list opens once the one before it is set. If a size is missing, follow Add a tubing or casing size that isn’t in the list.
Packers
- Open Packers and Plugs and choose Add Packer.
- Set the Placement Type: Tubing × Casing, Casing × Casing or Casing × Open Hole.
- Set its Depth. The form states the valid range when it can work one out, and warns Depth outside casing range if you go past it.
- Pick the casing strings the placement asks for: Inner Casing and Outer Casing for Casing × Casing, and Casing (Inner Element) for Casing × Open Hole. There is no size to type, because a packer is drawn across the gap between the things it seals.
Add Bridge Plug sits beside it and needs a casing string to be set in. If there is none, the form says Add a casing string to set a bridge plug in.
Perforations
- Open Perforations and choose Add Perforation.
- Set Top and Bottom. Top must be shallower than Bottom.
- Type a Formation if you want one. It is optional, up to 60 characters, and is added to the interval’s label on the drawing.
Good to know
- The bin on a card removes that component, after asking you to confirm.
- Warnings about clearances and casing order appear at the top of the panel. They advise and never stop you saving.
- If someone else is editing the schematic, it opens read-only, with no Save button, and says who holds it. A well that is read-only under your plan shows a Read-only badge on its page, and changes to it can’t be saved. See Plans, Trial and Full Access.